AIGUILLES D'AMORCE COURBEES DST-58 - 58mm

Reference: RR23-CLIQUETRAPTOR

Ratchet for RAPTOR kit

Please note that this ratchet is not compatible with the RAPTOR Kit. 1 Ratchet For ROLL-N-CUT kit

Reference: TB-102

Rope insert tool length of the rope: 9m (pour bus et poids lourds)

Rope insert tool.For the replacement of non-bonded windshields with rubber mouldings.The toll is delivered with a very resistant rope, the length of which (6 m) is enough. Can be used with private cars and trucks.

Reference: CAISSE-N399

Storage case L: 44 cm x H: 17 cm x W: 19 cm - 2nd LIFE - N399

In very good condition Only a few minor cosmetic flaws - 9 units available 2nd LIFE warranty: 6 months Storage case Length: 44cm - Width: 17cm - Height: 19cm

Reference: FSL240

Pinchweld scraper with interchangeable blade

Pinchweld scraper with interchangeable bladeThis may be the last pinchweld scraper you will ever buy! From now on.You may just buy blades. When the blade finally wears out, remove the two screws, pull out the old blade, drop in a new blade and tighten the two screws. These pinchweld scrapers are made of spring steel and are hard enough so they will not...

Reference: Z10RD

New COLD KNIFE BLADES SERRATED 19mm

REF-Z10RDNew ULTRAWIZ Cold knife bladeSold individually - Extra thin Cutting length: 19 mmCARTON OF 10

Reference: LBB-10

"Black" segmented rigid blades

Rigid blades "BLACK" segmented pack of 10 pieces for L2 and XL2

Reference: Z60

Special cold knife blade 60 mm

This blade series enables you to use a cold knife where you could never use it before ! The 60 mm long blade is intended to cut all those hard to reach PU bondings thatare far away from the glasses edge and where a normalcold knife blade could never reach. But also all lowerglass edges with surmounting wings and bonnets are aperfect field of application...

Reference: AIG-125

T-handles wire threader

Just lay the wire in the notched tip and pass it through the polyurethane by pushing the tool from the inside to the outside.In the way, you can release the window. Always place the flat surface of the wire threader on the window, so that the hollow tube is not deformed.- 120 x 26 x 10 mm - 20 g

Reference: Z7

Cold knife blade coated, extra fine 19 mm

Cold knife blade coated, extra fine - Sold individually- Cutting length: 19 mm- 20gCARTON OF 10

Reference: Z1

Cold knife blade 19 mm

Cold knife blade- Sold individually- Cutting length: 19 mm- 18gCARTON OF 10

Reference: WK2

Average, universal, flat BTB blade, 240mm

Average, universal, flat BTB blade, 240mm

Reference: FB110

Hook blade with U shape - 40mm

REF-FB-110 Lame à crochet en U Profondeur de coupe 40 mmvendue à l’unité

Reference: SD-21

Braided wire - ø 0,80 mm - 22.5M

Braided wire21 ml REPAREGLASSBraided wire The braided wire is made of three stainless steel resistant wires that are braided to one strand. The wire is anodized (with a traditional gold colour). It has a 0.80mm diameter.

Reference: DESTOCK-WK7L

Double manual handle for BTB blades

Double handle for BTB blade - Makes it easy to cut windshield and other glazing seals. Dimensions: 190 x 38 x 38 mm

Reference: FB194

Hook blade 110 mm

LAME A CROCHET EN U - 110 mm

Reference: LM-610

Long knife with a blade

Long knife with 1 blade Some vehicles have extra-long dashes. So you have to cut the bond from the inside. As long as the band of urethane is not too thick, you can use knives designed to cut urethane. Two lengths are available: 46 cm (standard) and 61 cm (designed for vehicles with a high windshield slope and with ewtra-long dashes). Both are made of...

Reference: SK130

Replacement blade for fsl 240 pinchweld scraper l:16mm

Replacement blade for fsl 240 pinchweld scraper l:16mm

Reference: CCR-819

EQUALIZER® cowling clip removal tool

EQUALIZER® cowling clip removal tool If expension-type cowling worked the way they were designed, you would simply unscrew the plastic screw and the clip would come out. Unfortunately, they seldom work correctly. Our cowling clip removal tool has a small sharp screw that screws into the plastic head and pulls the screw out. The clip will then collapse and...

Reference: DPO-585

Rivet Stem Remover

Rivet Stem Remover It is often necessary to remove dor glasses without breaking them. Drilling out the rivet so you can remove the door glass is easy if you can remove the rivet stem. Rivet stems are made of steel and are impossible to drill out. Our rivet stem remover has contoured end so it will sit over the rivet and align perfectly with the rivet...

Reference: SD-22

Braided wire in a spool - - ø 0,80 mm - 22ML

Braided wire in a spool REPAREGLASS ø 0.80 mm, length: 22 m, Wound on a plastic spool. 1083 NEWTON The wire to be cut is twisted according to our exact specifications from three strong stainless steel wires. The wire is anodised in a typical "gold" colour.

Reference: DSS-175

One-man wire cut-out tool

One-man wire cut-out toolREPAREGLASSOne-man wire cut-out toolThis tool acts like another person sitting inside the vehicle pulling the wire back after you havemade your cutting stroke.Attached to the swivel is a spring that acts as a second person; you pull the wire out to make your cut and the springs pulls the wire back in. The spring is attached to a...

Reference: FSP-4PCS

Set of 4 plastic scrapers

Set of 4 plastic scrapers

Reference: ZDK-395

Cold knife with neoprene coating

The REPAREGLASS neoprene-coated cold knife is an essential tool for windshield installation professionals. Designed for cold cutting, it features a neoprene coating that provides a safer grip while protecting the painted surfaces of the vehicle. Used worldwide for over 30 years, this knife has evolved to meet today's requirements: modern paints are more...

Reference: AIG-730

T-handles wire threader for cutting steel or nylon thread

T-handles wire threader for cutting steel or nylon thread

Reference: CROR-L

Brand: REPAREGLASS

Ball-tipped hook, with long shaft

Ball-tipped hook, with long shaft- 280 x 35 x 35 mm- 160 g

Reference: CZ-444

Clip removal tool

Reference: MRC1105-R4 - N423

Ratchet for ROLL-N-CUT kit - N423

Not available

Reference: WK4ZS

Serrated, deep offset, multi-purpose BTB blade, 140mm

Serrated, deep offset, multi-purpose BTB blade, 140mm

Reference: FSC-350

Brand: REPAREGLASS

Special scraper

REF. FSC-350SCRAPER (without blade)To scrape the old urethane bead. This scraper is universal due to thefact it can accept different blades width ( 13 mm – 16 mm – 20 mm)and angular bladesIts locking system with roll allow a quick and easy blade replacement

Reference: FB123

Cutting blade, straight 40 mm

profondeur de coupe : 40 mm longueur totale : 74 mm vendue à l'unité