Yeni Boya Koruma bükülmü? Ters B?çak 25mm «ULTRAWIZ»

Reference: FB157

Hook blade with U shape - 60 mm

LAME A CROCHET EN U - 60 mm

Reference: PH-1355

Spatula curved to remove the clips

Curved Door Upholstery Remover For removing plastic fasteners in confined places. It is the same upholstery remover as the one shown above, but it is instended for use on the front part of the door where the door jam will often interfere with the removal of the door panel. Place the notch in the tool over the fastener and pry the fastener out the hole. It...

Reference: PSD6

Parer blade 6mm

Parer blades (scraper not include)REF-PSD-6 Blade diameter 6 mmThese parer blades are especially good for cleaning the pinchweldfrom excessively applied polyurethane in curves and corners.Thereby the special shape reduces the risk of damaging the paintcompared to standard scraper blades. The blades are suitable for ourscraper tools FSC-300SPECIAL and...

Reference: LB10S-50

Rigid segmented blades for L2 and XL2 cutters - Pack of 50

Rigid segmented blades for L2 and XL2 cutters. Sold in packs of 50 blades. Blade size: 110 x 18 x 0.5 mm - 86 g

Reference: Z9

Cold knife blade coated, extra fine 38 mm

Cold knife blade coated, extra fine - Sold individually- Cutting length: 38 mm- 20gCARTON OF 10

Reference: WK24S

Long, serrated, deep offset, BTB blade, 240mm

Long, serrated, deep offset, BTB blade, 240mm

Reference: FB107

Hook blade with U shape - 60 mm

profondeur de coupe : 60 mmvendue à lunité

Reference: FOURREAUX-EXC

Sheathes for Excalibur - 100mm, 200mm and 300mm

Equalizer® sheaths are one of the key components of the Excalibur system thanks to their unique, patented design. They consist of a protective sleeve that surrounds the blade to prevent damage to the vehicle's interior trim, such as the dashboard, upholstery, and sensitive plastic parts. Available in three sizes (100 mm, 200 mm, and 300 mm), each sleeve...

Reference: MSP-211

BOX EXTRACTOR

Arm wiper pullers kit If you remove a bolted on windshield wiper a few months after the vehicle was builtthen it is usually not difficult to remove, but try removing the wiper arm two or threeyears after it was built. It can be almost impossible because manufacturers use onetype of metal on the wiper arm and a different type of metal on the wiper post. If...

Reference: CAISSE-N395

Storage case L: 44 cm x H: 17 cm x W: 19 cm - 2nd LIFE - N395

In very good condition Only a few minor cosmetic flaws - 1 Only one item available 2nd LIFE warranty: 6 months Storage case Length: 44cm - Width: 17cm - Height: 19cm

Reference: FB101

Hook blade with U shape - 60mm

REF-FB-101 Hook blade with U shapeCutting length: 60 mmSold individually

Reference: PRO-LAV

Special protector part to protect glass cleaner sprayer solution

REF. PRO-LAVMany of the wipers system includes a glass cleaner sprayer solution.The hose is integrated to the arm wiper and runs thanks to its movements. The sprayer couldbe damaged with an arm wiper puller. The tightning nut of the puller has to be located on the specialprotector of the center area of the cleaner sprayer. Untight the bolt which is...

Reference: FSC1.7B2

FEIN battery-powered knife - without blade, with battery

Discover a powerful, precise and completely autonomous solution for your automotive work. This FEIN cordless knife is designed to meet the highest demands of glass professionals, combining mobility, performance and reliability. Technical specifications: Battery voltage: 18 V Battery capacity: 5 Ah Oscillations: 10,000 - 19,500 rpm Amplitude: 2 x 1.7°...

Reference: GCC-506

Glass run channel cleaner

Glass run channel cleanerIf you have ever cleaned glass out of a glass run channel, you know the problem. Broken pieces of tempered glass will hide behind the lip of the glass run chanel and scrape the door glass when you roll it up or down. The glass run channel cleaner reaches behind that lip to remove even the most stubbornly-wedged pieces of glass...

Reference: DLH-511

Double-end moulding release tool

Double-end moulding release tool This heavy-duty tool is made of steel so it will not bend. It has a small rubber spacer through each end to the tool up off the glass about 1 mm. This is important for two reasons. First, it prevents the tool from scratching the glass. Secondly, it holds the end above the glass so there is less chance the tip will catch...

Reference: FB211

Serrated hook blade with U shape - 24 mm

Lame à crochet crantéeprofondeur de coupe : 24 mmvendue à l'unité

Reference: WK2

Average, universal, flat BTB blade, 240mm

Average, universal, flat BTB blade, 240mm

Reference: Z2

Cold knife blade 25 mm

Cold knife blade, extra fine- Sold individually- Cutting length: 25 mm- 18gCARTON OF 10

Reference: LM-610

Long knife with a blade

Long knife with 1 blade Some vehicles have extra-long dashes. So you have to cut the bond from the inside. As long as the band of urethane is not too thick, you can use knives designed to cut urethane. Two lengths are available: 46 cm (standard) and 61 cm (designed for vehicles with a high windshield slope and with ewtra-long dashes). Both are made of...

Reference: BOB-1.5-ROLL-OUT

Spool of 1.5km for roll-out 2000

Spool  of 1.5km - Round wire: 0.8 mm

Reference: CCR-819

EQUALIZER® cowling clip removal tool

EQUALIZER® cowling clip removal tool If expension-type cowling worked the way they were designed, you would simply unscrew the plastic screw and the clip would come out. Unfortunately, they seldom work correctly. Our cowling clip removal tool has a small sharp screw that screws into the plastic head and pulls the screw out. The clip will then collapse and...

Reference: Z1022

Cold knife blade

This special blade reaches the urethane between the wheel cover and the side of the windshield.Its unique shape allows you to unbond the windshield with a cold knife, without having removed the wheel cover (also bond) before. Once the windshield is removed, you can unbond the wheel cover, wihtout risking to damage the remaining material.- Sold...

Reference: Z11RD

New COLD KNIFE BLADES SERRATED 25mm

REF-Z11RDNew ULTRAWIZ Cold knife bladeSold individually - Extra thin Cutting length: 25 mmCARTON OF 10

Reference: CB1

Brand: REPAREGLASS

Steel or nylon piano wire locking clip

The locking clip replaces the original elastic band that holds the steel or nylon piano wire in place.

Reference: WK28XL

RIGHT HAND BTB BLADE 45MM

Right hand, BTB blade, 45 mm

Reference: Z1

Cold knife blade 19 mm

Cold knife blade- Sold individually- Cutting length: 19 mm- 18gCARTON OF 10

Reference: FB176

Cutting blade, straight - 40mm

Cutting blade, straightCutting length: 40 mmSold individually

Reference: LAME-STANDARD-EXC

Standard blades for Excalibur - 100 mm, 200 mm, and 300 mm

Designed for glass and windshield replacement professionals, Equalizer® standard blades are made of unbreakable mild steel, ensuring flexibility of use without risk of breakage. If they become bent, they can be easily straightened with pliers, extending their service life. They are easy and efficient to sharpen using a grinder, belt sander, file, or...

Reference: SD-21

Braided wire - ø 0,80 mm - 22.5M

Braided wire21 ml REPAREGLASSBraided wire The braided wire is made of three stainless steel resistant wires that are braided to one strand. The wire is anodized (with a traditional gold colour). It has a 0.80mm diameter.

Reference: WK28M

Right hand, BTB blade, 25mm

Right hand, BTB blade, 25mm