New Paint Protection Reverse Bend Blade 19mm « ULTRAWIZ »

Reference: AIG-789

Straight wire threader

Many technicians remove windshields by starting the wire through the top and bottom center of the windshield, then cutting towards each side. So as to push the cutting wire into the urethane, especially where there is a wide surface of urethane, we recommend using the wire threader. The slot (1,2 mm only) and the cutting wire are pushed together into the...

Reference: DLH-511

Double-end moulding release tool

Double-end moulding release tool This heavy-duty tool is made of steel so it will not bend. It has a small rubber spacer through each end to the tool up off the glass about 1 mm. This is important for two reasons. First, it prevents the tool from scratching the glass. Secondly, it holds the end above the glass so there is less chance the tip will catch...

Reference: TKS-100

Trapezoid blades

Trapezoid blades. In a pratical dispenser. Our replacement blades for utility knives are 0,6 mm thick, so they are very sturdy. These blades are in a safety dispenser with a suspension hook so as to avoid any risk of injury. You take new blades by sliding them out from the above side of the dispenser while youdispose of the worn out blades by sliding them...

Reference: FB107

Hook blade with U shape - 60 mm

profondeur de coupe : 60 mmvendue à lunité

Reference: WFA-500

Arm Wiper puller

REF. WFA-500Arm Wiper pullerArm wiper puller especially designed forVolkswagen rear window models, Audi, Skoda,Seat, but also many others.Untight the button from the arm but do not release it( could caused damages on the plasticcompartments of the arm.) Position the jaw on thearm of the wiper, tight manually first, then use aratchet 3/8 to strongly tight...

Reference: FB176

Cutting blade, straight - 40mm

Cutting blade, straightCutting length: 40 mmSold individually

Reference: Z30

Special cold knife blade 30 mm

This blade series enables you to use a cold knife where you could never use it before ! The 60 mm long blade isintended to cut all those hard to reach PU bondings that are far away from the glasses edge and where a normalcold knife blade could never reach. But also all lowerglass edges with surmounting wings and bonnets are aperfect field of application...

Reference: FSB103

Saw disk ø 80 mm

Disque de scie ø 80 mm vendu à l'unité

Reference: CS-RC14

Handable rolling Tool-box

Toolbox on wheels Size: L:62 x W:30 x H:32 cm + 10cm in height with wheels 4 drawers of 22 x 20cm

Reference: WK5S

SERRATED LONG FLAT BLADE 130MM

Serrated long, flat blade 130mm

Reference: NMT-448

Mechanical pick up

Mechanical pick up The use of telescopic magnet could be sometimes impossible to use because of non ferrous items. It is times like these when you need our Mechanical Pick-Up. It is designed with steel fingers that are spring-loaded that will grip an item up to 2,5 cm in diameter.

Reference: WK27S

Left hand, BTB blade, 19mm

Left hand, BTB blade, 19mm

Reference: WK10HD

BTB pneumatic knife (automatic PB cutting)

The BTB pneumatic knife is the ideal tool for quick and precise cutting of windshields, both inside and outside the vehicle. Compact, lightweight (1.1 kg) and easy to handle, it significantly reduces physical effort for the user while offering optimal cutting performance. Its design reduces the risk of blade overheating and impact on the glass. Supplied...

Reference: CAISSE-N397

Storage case L: 44 cm x H: 17 cm x W: 19 cm - 2nd LIFE - N397

In very good condition Only a few minor cosmetic flaws - 1 Only one item available 2nd LIFE warranty: 6 months Storage case Length: 44cm - Width: 17cm - Height: 19cm

Reference: LAME-DECOUPE-NINJA

Cold cutting blade: Equalizer Ninja

Specially designed for the Equalizer® Ninja pneumatic knife, these cold cutting blades offer optimal precision and remarkable efficiency, suitable for use on all types of windshields. Their design absorbs vibrations while ensuring a clean and fast cut, even in the most difficult-to-reach areas.

Reference: LM-460

Long knife with a blade

Long knife with 1 blade Some vehicles have extra-long dashes. So you have to cut the bond from the inside. As long as the band of urethane is not too thick, you can use knives designed to cut urethane. Two lengths are available: 46 cm (standard) and 61 cm (designed for vehicles with a high windshield slope and with ewtra-long dashes). Both are made of...

Reference: WKBX

Specific case for BTB material

SPECIFIC CASE FOR BTB MATERIALREF. WKBX

Reference: FB111

Hook blade with U shape - 95 mm

profondeur de coupe : 95 mmvendue à l' unité

Reference: HDW5634FEUTRE

Felt for RAPTOR device

Felt for RAPTOR device

Reference: VKD-44A

Brand: REPAREGLASS

SQUARED CUTTING WIRE in a spool- Size: 0.6mm - 44 ML

SQUARED CUTTING WIRE in a spool REPAREGLASS Surprising but true! The cutting resistance of the squared wire is far higher than the one of the common round wire. Try it, you will see!Squared wire - 0,6 x 0,6 mm,- length: 44m, on plastic spool.- 100 x 22 mm - 110 g

Reference: AIG-730

T-handles wire threader for cutting steel or nylon thread

T-handles wire threader for cutting steel or nylon thread

Reference: CS-RC

TOOL-BOX WITHOUT ROLLING

Reference: FSB102

Saw disk ø 63 mm

disque de scie ø 63 mm vendu à l'unité

Reference: Z9

Cold knife blade coated, extra fine 38 mm

Cold knife blade coated, extra fine - Sold individually- Cutting length: 38 mm- 20gCARTON OF 10

Reference: DPO-585

Rivet Stem Remover

Rivet Stem Remover It is often necessary to remove dor glasses without breaking them. Drilling out the rivet so you can remove the door glass is easy if you can remove the rivet stem. Rivet stems are made of steel and are impossible to drill out. Our rivet stem remover has contoured end so it will sit over the rivet and align perfectly with the rivet...

Reference: RAPTOR

Windshield cutting system with automatic vacuum - RAPTOR

The  Raptor™ is a cord and wire auto glass removal device designed from the ground-up to dramatically improve the power of the vacuum cup with the integration of our AirForce™ Constant Vacuum Cups. This technology has been specifically developed to create a quick placement and constant vacuum to the glass so the Raptor™ stays in place and resists...

Reference: CAISSE-N398

Storage case L: 44 cm x H: 17 cm x W: 19 cm - 2nd LIFE - N398

In very good condition Only a few minor cosmetic flaws - 1 Only one item available 2nd LIFE warranty: 6 months Storage case Length: 44cm - Width: 17cm - Height: 19cm

Reference: RK-100A

Squeegee blades for glass and plastic

These squeegee blades offer an effective solution for cleaning and preparing glass and plastic surfaces. Ideal for removing adhesive residues, paint or stubborn dirt, they guarantee precise, careful work without damaging delicate surfaces. These blades combine durability and safety. Their razor-sharp cutting edge ensures optimum use for all workshop...

Reference: Z10RD

New COLD KNIFE BLADES SERRATED 19mm

REF-Z10RDNew ULTRAWIZ Cold knife bladeSold individually - Extra thin Cutting length: 19 mmCARTON OF 10

Reference: Z2

Cold knife blade 25 mm

Cold knife blade, extra fine- Sold individually- Cutting length: 25 mm- 18gCARTON OF 10